12 days to Frostgrave ……..4

4? where is three? Lost in time. Taking too much time to paint, not speaking of those printers - slower than an asmathic sloth. Painted small bits of scenery yesterday, lowered my paint standard. All the bits on the picture are printed home - but none of them is a home design. Today was in … Continue reading 12 days to Frostgrave ……..4

Advertisements

12 days to Frostgrave ……….2

Day 2 The paint workbench was littered with billions (rough estimation) of paint pots and miscellaneous stuff. Launch a print, then use an hour to displace stuff from the table to another place. After the successful cleaning operation, an amount of 20 cm by 20 cm was obtained between mountains of various things. Enough for … Continue reading 12 days to Frostgrave ……….2

3D Printed 4mm micro-army

After a few test, production began. Low temperature for PLA - about 182°, low print jerk - 5mm/s, low print speed - 15mm/s. Better result. Cavalry modelled and printed, then bowmen modelled. Quick paint of 96 infantry figures and 28 cavalry in less than 3 hours (undercoat, drying time and coffee time included). A close view … Continue reading 3D Printed 4mm micro-army

King of War in 4 mm

A complete army of night Goblins was painted a few years ago. With Goblin catapult, Giant, some Orcs, fanatics etc. My opponent was playing with a Bretonian army adapted for the rule "King of War", but never finished to paint his huge 28mm figures. Not speaking about the  massive surface needed for a quite small … Continue reading King of War in 4 mm