3D Printed 4mm micro-army

After a few test, production began. Low temperature for PLA - about 182°, low print jerk - 5mm/s, low print speed - 15mm/s. Better result. Cavalry modelled and printed, then bowmen modelled. Quick paint of 96 infantry figures and 28 cavalry in less than 3 hours (undercoat, drying time and coffee time included). A close view … Continue reading 3D Printed 4mm micro-army

Advertisements

King of War in 4 mm

A complete army of night Goblins was painted a few years ago. With Goblin catapult, Giant, some Orcs, fanatics etc. My opponent was playing with a Bretonian army adapted for the rule "King of War", but never finished to paint his huge 28mm figures. Not speaking about the  massive surface needed for a quite small … Continue reading King of War in 4 mm

Supports for 3D dungeon

Nothing more boring than building a one floor dungeon. As it takes hours and days to print and paint pieces, using those precious bits of plastic to obtain elevations was not satisfying. And all these walls used as supports cannot longer be used to enlarge the dungeons. It seemed more convenient to quickly print flat … Continue reading Supports for 3D dungeon

A Diet for a Fat Dragon

After a hard month of work for the printer, and an even more hard work for the brushes, here is the replacement of my old Hirst Art plaster dungeon. Lighter (2 kg against 20kg) with clips that allow rooms and corridor to be assembled separately, then put on the table when needed. Printed with 200 micron … Continue reading A Diet for a Fat Dragon